FJ Cruisers of Northern California

Remote unlock button

Does anyone know how to program the key fob to unlock all doors with one push? I'm not sure if this is even possible, but I was hoping it would be =0

▶ Reply to This

Replies to This Discussion

Permalink Reply by DWH on August 12, 2012 at 9:01pm

It is possible to do. Dealers can do it, I do not know if it can be done otherwise.

▶ Reply

Permalink Reply by Robo on August 12, 2012 at 9:32pm

Found this on TW awhile back while looking for new fob install instructions. I haven't tried it, but similar steps worked for me programming the the fob.

"The vehicle should meet the following conditions before proceeding; *The key is NOT in the ignition *Driver’s door is OPEN (The others are CLOSED) *Drivers door UNLOCKED
1) INSERT and REMOVE the key from the ignition cylinder, TWICE within 5 seconds
2) CLOSE and OPEN the driver’s door TWICE within 40 seconds
3) INSERT and REMOVE the key into the ignition cylinder
4) CLOSE and OPEN the driver’s door TWICE within 40 seconds
5) INSERT the key in the ignition and CLOSE the driver’s door
6) Turn the ignition switch from LOCK to ON and back to LOCK at approx. 1 sec. Intervals “ 2” times to enter REWRITE MODE
7) REMOVE the key from the ignition (The door locks are cycled LOCK-UNLOCK within 3 seconds TWICE to let you know that you have selected REWRITE MODE)
8) Within 40 seconds press BOTH the LOCK & UNLOCK buttons on the transmitter simultaneously for 1 second (Press and release).
9) Within 3 seconds press and release the LOCK button on the same transmitter (The door locks will cycle ONCE if the transmitter was recognized and TWICE if it was not recognized {if you get two cycles start over}).
10) Within 40 seconds repeat step 8 and 9 with any other transmitters you wish to program
11) One of the following will END the Rewrite mode; *40 seconds elapses *Drivers door is opened *Key inserted into the ignition cylinder *4 transmitters are registered

edit: apparantly in step 9 if you push unlock instead of lock, you can unlock all doors with one button push. "

Like I said, I haven't tried it, but it was just as much as a hassle programming a new fob. Good Luck!

▶ Reply

Permalink Reply by John Brown on August 12, 2012 at 9:38pm

Steps outlined in this link seem easier to understand ...

http://tycreek.com/p/fj/misc.htm

▶ Reply

Permalink Reply by cypilk on August 13, 2012 at 5:55pm

Woah, thanks!

▶ Reply

Permalink Reply by cypilk on August 19, 2012 at 11:52am

It never worked. Tried a bunch of times. Thanks anyway =\

▶ Reply

Permalink Reply by Slow on August 5, 2013 at 6:33pm

Necro post but did you ever get this figured out?If you look in the manual it lists optional settings that can be programmed by the dealer (unless you have access to a toyota or aftermarket scan tool) and 1 touch unlock is one of them (at least on the 2013's)