FJ Cruisers of Northern California
Body Mount Chop Welding by Bozly !
John over at BoxTec in Alameda has graciously offered to weld BMC's for folks. He says that the 3rd of March (Saturday) is looking like a good day to do it, or possibly a later date.
.
If you'd like to get yours done he asks the following:
Have the cut done and the cap prepared. The cap material should be at least 10 ga (1/8") if not 3/16" steel. There is a template that works pretty well and BZ knows how it works. If anybody still needs the BMC done, you should talk to BZ and have that done before the welding date. If its done right all it takes is a straight piece of flat bar.
Post up your name here and state if you only need the cap welded on, or if you need the BMC and the cap welding.
.
Thanks everyone, and thanks especially to Bozly !!
Views: 768
Replies to This Discussion
-
Permalink Reply by downy_ball on
-
thanks bz... fixed.
-
Permalink Reply by DarrellBuddy321 on
-
Count me in! I need mine welded up
-
Permalink Reply by manoweb on
-
But who has the plasma cutter? I have also heard that with the proper wheel alignment (full caster) the body chop may not be needed.
-
Permalink Reply by Keltic on
-
bz iam in on BMC and the cap welding thanks for your help
need to set up a time ,day . going to fremont wensday to get my revtek lift final torqe
get off work in scotts valley around 3.30 m/f
much respect
keltic
-
Permalink Reply by Bozly on
-
The third is looking good for me. I need to tune the welder up and get some wire this week but as far as I can tell now, Saturday will be A-ok.
-
-
Thanks Bozly !
And just a quick reminder - if you need the BMC done, please have that done before the 3rd - contact BZ to set that up.
If it's only the welding you need done, please have the cap ready / formed so Bozly only needs to weld it up.
Thanks everyone !!
- ‹ Previous
- 1
- 2
- 3
- Next ›
Badge
NorCal FJ Twitter Feed
The NorCal FJ Shop
NorCal FJ Network Status
© 2024 Created by NorCal FJs.
Powered by
