WTB UCAs w/ 1.25" uniballs preferably Camburg

Replies to This Discussion

Permalink Reply by Markie Sharkie on March 27, 2013 at 12:51pm

Camburg makes a ball-joint version as well. It's cheaper too and you can use your OEM ball-joints.

I'm ordering a pair of these but am gettng Moog ball-joints. WheelersOffroad.com will install the joints and ship for a total of ~$510 (cost of parts, labor, and shipping to CA). The UCA's alone are about $400 on Camburg's website.

• ▶ Reply

Permalink Reply by Kabe2611 on March 27, 2013 at 6:13pm

I was checking those out. I would have to buy new ball joints because I tore both boots when I took them off the spindles while installing the coilovers.........oooops.

• ▶ Reply

Permalink Reply by Markie Sharkie on March 28, 2013 at 7:13am

Yup I did that too. The Moogs come with boots already on them and WheelersOffroad will redo the install if they mess it up. All you have to do it bolt the balljoint to the spindle and then the arm to the truck.

• ▶ Reply

Permalink Reply by Kabe2611 on March 28, 2013 at 7:41am

I checked out Wheelers after I read your reply. Thanks for the heads up. My issue now is that I hear pros and cons about ball joints as well as pros and cons about uniballs.......

• ▶ Reply

Permalink Reply by Markie Sharkie on March 28, 2013 at 12:20pm

I mostly hear that uniball is the best if you use your rig a lot. Mine is mostly my daily driver, and I'm cheap so I'm sticking to the ball-joint setup.

• ▶ Reply

Permalink Reply by Kabe2611 on March 28, 2013 at 1:01pm

I hear ya..........I might have a great deal coming from socal. If that falls through I may go your route.......

• ▶ Reply