NorCal FJs

FJ Cruisers of Northern California

Sway Bar link Bolt

The upper bolt of the sway bar linkage (the one you tighten to 52lbs) appears to be rotating around freely, the other side isn't. Was able to get both of the to the right torque (obviously had to hold the other side of one in place). Should i be concerned and replace that entire linkage?  dont think i can replace the bolt it has a sealed rubber boot. Thanks in advance!

Views: 18

▶ Reply to This

Replies to This Discussion

Permalink Reply by pkelly72 on January 1, 2011 at 3:38pm
I'm sorry but front or rear? I'm guessing if you were able to tighten to spec. It should be alright. I would grab it and shake it for all my worth to see if it gives at all. If nothing happens I would then just monitor it.

If it's the rear, I've got a set
of the extended ones if your interested
Permalink Reply by daPitbull on January 1, 2011 at 4:19pm
There is an allen wrench fitting on that bolt to help with tightening and loosening the link.
Permalink Reply by NestahEdition on January 1, 2011 at 5:06pm

Yes, 6mm allen wrench for both front and rear sway bar bolts.

 

Permalink Reply by Estysalinas on January 1, 2011 at 10:10pm
ah brilliant! thanks :-)

RSS

Badge

Loading…

Get Badge

NorCal FJ Twitter Feed

The NorCal FJ Shop

The Black Bear Bag
Use it for school, as a bug-out bag, or for your spy gear that only you know about.

SHOP NOW!

NorCal FJ Network Status

© 2024   Created by NorCal FJs.   Powered by

Badges  |  Report an Issue  |  Terms of Service

Sign in to chat!