Snorkel install slide show

Replies to This Discussion

Permalink Reply by Steve Hope on May 5, 2013 at 5:18pm

Also it is wise to add locktite to the studs before assembly and add silicone sealer to the drain holes in the air box.

Steve Hope.

• ▶ Reply

Permalink Reply by DX FJC on May 5, 2013 at 8:17pm

Yeah I used some blue Loctite on the studs on the snorkel side, but I also packed between the snorkel body and the fender washers with some dumb-dumb then squeezed a little piece over the nuts. That 3M seam sealer works good anytime you mount anything that you don't want to rattle, leak water, or works as a sound deadener. I did it to keep the water from between the snorkel and fender.

• ▶ Reply