NorCal FJs

FJ Cruisers of Northern California

OK, I'm the guy that recently bought a 2012 FJ Cruiser that was pre rolled, probably low speed off road rollover. No regrets buying it that way, I love it. Turned out no motor mounts were broken. It's a real conversation starter as everyone assumes I rolled it. I just say yeah, you should see the car of the guy who took my parking space. It had plenty of dents already so it was fun adding some scratches without worries while I recently spent two weeks going all over backroads in Nevada and other counties. If not for the GPS on my iPad I would still be lost. Anyway, I am such a noob that I don't know what options this 2012 automatic 4WD came with, and which ones are working properly. Pretty sure that with the Bilstein shocks it must have the offroad package.

There is an issue with the warning light icon staying on that shows a car with skid marks (is that traction control?) The dealer did a diagnostic and said the chip in the master brake cylinder was bad and the whole brake assembly would need to be replaced for over $1800. I am not convinced it couldn't just be a sensor on a brake thats bad. The front driver side had a stabilizer bar tie that had broken in the rollover. I often feel a thud when I let off the brake. Could be related to this light being on. My brother thinks it could be a stuck brake caliper that I feel releasing when the car starts to move forward.

Pushing the skidding car icon button does not do seem to do anything, and I assume it is because of the chip issue. Also can someone explain what A trac is and how I engage it and how to tell if it is working? Same question for the RR diff lock button. I am embarrassed to say I don't know how these things work and what they do.

Even without these I was able to do a lot and got a pretty good feel for the strengths and limitations of the truck. I'll try to post pics or video when I get time.

Views: 60

Reply to This

Replies to This Discussion

It has been a while since I had a FJC and used Atrac but here is what I remember. A-trac uses the anti lock brake sensors to apply brakes to wheel that is spinning. This is supposed to be equivalent to a poor man's locker slowing a spinning wheel and diverting drive to wheel with traction. Atrac can be applied by the button on the center console. When Atrac is working you will hearing a pumping noise and vibration in the brake pedal letting you know it is activated.

Rear diff lock is activated by the button on the center console. if I remember correctly, you need to be in low range and under 5 or 10 miles an hour to activate the rear locker. You will know the locker is active if you try and turn the truck, the differential in the speed of the outside wheel versus the inside will cause skidding and chirping of the rear tire. I would only try and engage the locker in a dirt lot so you are not loading up the rear axles on the street.

Good luck with your truck. 

From the "Blue Room"

Trac : Traction control. All FJ's have this, both 2WD & 4WD. Works automatically when ignition is started (no push button needed). Works by applying brakes and controls (decreases) engine throttle to give added traction to varying wheels when system detects wheel slippage/spinning ("think spinning your wheels on ice"). Works all the time in 2WD and in 2H & 4H (AT) or HL (MT). This system basically helps to maintain traction in slippery conditions such as wet/icy for forward movement by applying brakes and controlling engine throttle to regain/maintain traction as a safety feature.
TRAC is disabled in 4LO. Again, you don't want this system to control engine power when you are climbing obstacles.

ATRAC : More aggressive form of TRAC & for 4WD OFF ROAD use only. Does the same thing as TRAC except it doesn't cut/control engine throttle. Instead, it transfers torque from slipping/spinning wheel(s) to non slipping wheel. This gives added traction & forward momentum to overcome Off-road obstacles. This can only be engaged while in 4LO (AT) or LL (MT) and by pressing the "ATRAC" switch.
Also, only 4WD models with the Rear Diff Locker have ATRAC capability. Even then, you need the $50 ATRAC switch installed to use this system if you didn't purchase either Upgrade Pkgs with your FJ (UP or UR).
*AT: to go into 4Lo, stop, put into Nuetral, then shift into 4Lo (short knob).
MT: refer to manual, sorry I have the AT.

Auto LSD: found on 2WD models. Similar to ATRAC for 4WD. Must press the Auto LSD button/switch to activate it.

VSC (vehicle stability control) : integrates ABS, TRACtion control, engine control, etc to prevent the vehicle from skidding when cornering. Prevents oversteering or understeering & will save your ass if your car loses control (Thai). Detects angular momentum and tries to control direction of skid. VSC is automatically activated when the FJ reachs 9mph or 15km/h.
*VSC automatically turns itself off (VSC off light on dash comes on) when 4H/HL or 4Lo/LL is activated (AT/MT) or when the Rear Diff is locked. VSC is for preventing rollovers at high speeds thus not used while wheelin' in 4Lo/4H.


Rear Diff Locker
: Not all 4WD models come with this. Switch/button activated. You must be in 4Lo or LL. It locks the rear axle so that it acts as one rod. If one wheel turns, so must the other so that not all power/torque is lost to the spinning wheel. Diff b/t Rear Locker and ATRAC is that with
Rear Diff Locker, both rear wheels spin in unison and steering tends to be rather difficult (so be careful near small ledges, ruts, drop offs). ATRAC, rear wheels are not locked and steering is not comprimised so you have more control of the vehicle. Apparently one works better than the other for certain situations while wheelin or you can do the Atrac-Locker Hack and have the best of Both worlds.

So at relatively high speeds TRAC will slow you down & aid in traction control in slippery situations, while VSC will give your more control during turns, skids, and saving your ass (roll over prevention).

While ATRAC and Rear Diff Locker is specifically for use in 4LO. While either of these are engaged, the TRAC and VSC is turned off. This makes sense, b/c they are safety systems to slow you down when you're going to fast, while ATRAC and RDL will aid to move you forward when you're going too slow or stuck.

Other Recommendations: Not necessary to be in 4H when it's raining or lightly snowing in the city, since this will deactivate VSC. VSC is what will save your ass at high speeds (per Thai). If you stay in 2H, you have TRAC and VSC to make necessary corrections if you slip & slide. If you do choose to put it in 4H for these situations, at least you still have TRAC working for you. But again, Thai says TRAC is turned off after 40+ mph or so. Many here feel you shouldn't be going fast (>40mph) while in 4H. 4H is probably more appropriate if you encounter thick/compacted snow or icey roads as FJJack mentions. You can quickly find out which is better with a test this winter. Try 2H and 4H and make up your own mind.

4H and 4L should generally be reserved for off roading use. 4H for light trails (gravel/dirt roads) and 4Lo for mod-large rutts/rocks. Obviously if a meteorite hits your town and all hell breaks loose then by all means put her in 4H/4Lo as needed.

RSS

Badge

Loading…

NorCal FJ Twitter Feed

The NorCal FJ Shop

The Black Bear Bag
Use it for school, as a bug-out bag, or for your spy gear that only you know about.

SHOP NOW!

NorCal FJ Network Status

© 2024   Created by NorCal FJs.   Powered by

Badges  |  Report an Issue  |  Terms of Service