FJ Cruisers of Northern California

I put the 1/4 inch spacer in the front. Questions.

So. I gained 1/2 inch on that side. Driver side. But I also gained 1/2 on the passenger side so I didn't actually even out. Also, now the car feels 'teeter tottery' when cornering or braking. Any thoughts?

▶ Reply to This

Replies to This Discussion

Permalink Reply by Bz on February 24, 2012 at 12:20pm

did you install the other 1/2 spacer on the other side? if not there's your problem....

if you are trying to just even out the gangsta lean, then you would only need the 1/4 spacer on the drivers side.

If you want 1/2 lift and and get rid of the lean you would need to add the 1/4 to the drivers side

▶ Reply

Permalink Reply by Shaman Rawb on February 24, 2012 at 12:22pm

When I measured it, I was higher on the driver side by 1/2". So I installed the 1/4 inch spacer on that side only hoping to level it off. 1/4 spacer= 1/2 lift. I did get a 1/2 lift on the driver side, but I ALSO got a 1/2 higher on the passenger side, and the teeter totter effect. I only installed a 1/4 inch spacer on the driver side.